Yun's Piano Tuning and Service
  • Home
  • Work
  • Life
  • About

Pin Block Making

5/22/2022

0 Comments

 
The old pin block on this Mason&Hamlin AA does not hold tuning pins tight anymore. It will be replaced. The original one has 8+ layers of hardwood, possibly maple. We are able to make a 5 layer panel with wood grains 90 degrees between each layer.
Jude, the shop owner, and Ellie, our summer apprentice, milled and put together the five layers of hard maple. Since our press is small, the big panel is cut into two pin blocks, narrow on the bass and wide at treble. 
The wood is placed into a cast iron tray, then the press. There's sufficient glue between each layer and between cross pieces. 
Tighten the small piece of cast iron in front to push cross pieces tight together in the press. The air pumps push the pin block tight from top. One day we'll have a bigger air press so we don't need to cut the penal in half before gluing layers together. One day...
2 days later, the pin blocked is removed from press and let dry in room temperature. Five layers nice and tight. It doesn't look pretty for now. It'll look much better after milling in the future.
0 Comments



Leave a Reply.

    Archives

    March 2023
    February 2023
    January 2023
    December 2022
    November 2022
    October 2022
    September 2022
    August 2022
    July 2022
    June 2022
    May 2022
    April 2022
    March 2022
    February 2022

Powered by Create your own unique website with customizable templates.
  • Home
  • Work
  • Life
  • About