Yun's Piano Tuning and Service
  • Home
  • Work
  • Life
  • About

Bind Bar

7/30/2022

0 Comments

 
According to soundboard thickness and formula, mark how deep the bind bar goes.
The router jig is designed by David Hughes. Jude, the shop owner, marked where the router handle shall be on the plexiglass. Rout a little at a time so the wood won't chip.
Put soundboard in piano to check how well (or bad) the routing job is done. Adjust accordingly. Then sand the glue surface flush.
The bottom clamping jig is cut to accommodate the ribs. Check width of bindbar between top of bevel and soundboard edge, trim premade & over sized bindbar to width.
Glue on bindbar, clean glue squeeze-out thoroughly. Let dry at lease 1 hour before unclamping. Great demo by shop owner Mr. Jude Reveley. 
0 Comments



Leave a Reply.

    Archives

    December 2022
    November 2022
    October 2022
    September 2022
    August 2022
    July 2022
    June 2022
    May 2022
    April 2022
    March 2022
    February 2022

Powered by Create your own unique website with customizable templates.
  • Home
  • Work
  • Life
  • About